Question
When I enable secure boot in X10DRC-LN4+, it shows message "WARNING: CSM is Loaded! Disable the CSM in Setup. Repeat operation after Reboot to ensure UEFI Video (GOP) driver is operational.".
Answer
In order to enable secure boot, try processor below:


  1. Boot into BIOS >> Advanced >> PCIe/PCI/PnP Configuration, Change the “onboard Video Option ROM” from “Legacy” to “EFI”. Save and exit the BIOS.

  2. Boot system to BIOS again. Then go to Security >> Secure Boot. In “Key Management”, enable the “Default Key Provision”.

  3. Disable the “CSM Support”.

  4. Enable the “Secure Boot”.

Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
H A R R
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region